eSUN PLA-Matte Rainbow 3D printing filament, 1.75 mm, 1 kg, Rainbow b
In your cart: 0
Delivery options to:
LatviaeSUN PLA-Matte Rainbow is a 3D printing filament combining a matte finish with rainbow colour gradients. This Rainbow b variant creates colour variations using a single spool, with a filament diameter of 1.75 mm and a weight of 1 kg.
Finish and applications
The smooth, matte surface reduces the visibility of light reflections. It suits decorations, display figurines, cosplay props and prototypes, with printed supports that are easy to remove. Mechanical parts require appropriately selected requirements.
Printing settings
- Temperatures: nozzle 210–230 °C and build plate 65 °C.
- Equipment: a PEI build surface and 0.4 mm nozzle are recommended.
- Speed and cooling: below 300 mm/s with the fan at 100%.
- Preparation: drying at 60 °C for over 8 hours is recommended before printing.
For a better surface finish, enable Z-seam alignment and start point alignment, disable Z-axis lift during travel moves and optimise the print path. Reduce the print speed if necessary.
Use limitations
Recommended mainly for indoor use, this material is not resistant to UV radiation, acids or bases. Its heat deflection temperature is 50.2 °C at 0.45 MPa. Finished prints should not be exposed to high temperatures, such as inside a hot car or in strong sunlight.
| Manufacturer | eSUN |
|---|---|
| Model | PLA-Matte Rainbow |
| Type | 3D printing filament |
| Material | PLA-Matte Rainbow |
| Colour | Rainbow b |
| Finish | Matte |
| Filament weight | 1 kg |
| Filament diameter | 1.75 mm |
| Density | 1.329 g/cm³ |
| Nozzle temperature | 210–230 °C |
| Build plate temperature | 65 °C |
| Recommended build plate material | PEI |
| Recommended nozzle diameter | 0.4 mm |
| Print speed | Less than 300 mm/s |
| Fan speed | 100% |
| Recommended drying | 60 °C for over 8 hours |
| Heat deflection temperature | 50.2 °C (0.45 MPa) |
| Tensile strength (X-Y) | 39.81 MPa |
| Tensile strength (Z) | 16.23 MPa |
| Elongation at break (X-Y) | 5.75% |
| Elongation at break (Z) | 1.80% |
| Flexural strength (X-Y) | 65 MPa |
| Flexural strength (Z) | 26.6 MPa |
| UV resistance | No |
| Applications | Decorations, cosplay, prototyping, mechanical parts with appropriately selected requirements |
| EAN | 6922572225343 |
|---|
Is this filament suitable for outdoor prints?
It is recommended mainly for indoor use because it is not resistant to UV radiation, acids or bases. Prints should not be exposed to high temperatures, including inside a hot car or in strong sunlight.
Should the filament be dried before printing?
Drying at 60 °C for over 8 hours is recommended before printing.












Gudri pirkumi vienuviet