eSUN PLA-Matte Rainbow 3D printing filament, 1.75 mm, 1 kg, blue-green
In your cart: 0
Delivery options to:
LatviaeSUN PLA-Matte Rainbow is a blue-green 3D printing filament that combines colour gradients with a smooth, matte finish. A single spool creates changing shades within your models, while the matte surface reduces the visibility of light reflections.
Applications and limitations
Use it for decorations, decorative figurines, cosplay props and prototypes. Suitability for mechanical parts depends on appropriately selected requirements. Support structures are easy to remove.
The material is recommended primarily for indoor use because it is not resistant to UV radiation, acids or bases. Its heat deflection temperature is 50.2 °C at 0.45 MPa. Finished prints should not be exposed to high temperatures, such as inside a hot car or in strong sunlight.
Printing settings
- Temperatures: nozzle 210–230 °C and build plate 65 °C; a PEI surface and 0.4 mm nozzle are recommended.
- Speed and cooling: print below 300 mm/s with the fan set to 100%.
- Preparation: drying at 60 °C for more than 8 hours is recommended before printing.
For better surface quality, enable Z-seam alignment and start point alignment, disable Z-axis lift during travel moves and optimise the print path. Reduce the print speed if needed.
| Manufacturer | eSUN |
|---|---|
| Model | PLA-Matte Rainbow |
| Type | 3D printing filament |
| Material | PLA-Matte Rainbow |
| Colour | Blue-green |
| Finish | Matte |
| Filament weight | 1 kg |
| Filament diameter | 1.75 mm |
| Density | 1.329 g/cm³ |
| Nozzle temperature | 210–230 °C |
| Build plate temperature | 65 °C |
| Recommended build plate material | PEI |
| Recommended nozzle diameter | 0.4 mm |
| Print speed | Less than 300 mm/s |
| Fan speed | 100% |
| Recommended drying | 60 °C for more than 8 hours |
| Heat deflection temperature | 50.2 °C (0.45 MPa) |
| Tensile strength (X-Y) | 39.81 MPa |
| Tensile strength (Z) | 16.23 MPa |
| Elongation at break (X-Y) | 5.75% |
| Elongation at break (Z) | 1.80% |
| Flexural strength (X-Y) | 65 MPa |
| Flexural strength (Z) | 26.6 MPa |
| UV resistance | No |
| Applications | Decorations, cosplay, prototyping, mechanical parts with appropriately selected requirements |
| Recommended use environment | Primarily indoors |
| Resistance to acids and bases | No |
| EAN | 6922572224841 |
|---|
Can finished prints be used outdoors?
The material is recommended primarily for indoor use as it is not resistant to UV radiation, acids or bases. Finished prints should not be exposed to high temperatures, such as inside a hot car or in strong sunlight.
Should the filament be dried before printing?
Drying at 60 °C for more than 8 hours is recommended before printing.












Gudri pirkumi vienuviet