eSun PLA-Matte Dual filament 1.75 mm, 1 kg, green-purple
In your cart: 0
Delivery options to:
LatviaeSun PLA-Matte Dual is a green-purple PLA filament for FDM 3D printing. Two separate colours share a single strand, allowing two-colour models without changing filament during printing. This variant has a 1.75 mm diameter and a net filament weight of 1 kg.
Matte finish and model processing
The matte finish reduces the visibility of printed layers. Low shrinkage, minimal warping and easy support removal make the material suitable for decorations, cosplay accessories, large models and prototypes used to explore initial design concepts.
Feeding and print settings
- Filament feed: even feeding and low brittleness help reduce the risk of nozzle clogs and filament breakage.
- Feed pressure: the material is relatively soft, so excessive pressure can hinder proper feeding.
- Temperature and speed: use a nozzle temperature of 215–230 °C, a bed temperature of 45–60 °C and a print speed of 40–300 mm/s.
- Cooling: the specified setting is 100%.
The printing parameters are based on a 0.4 mm nozzle. Settings may differ when using other nozzle diameters.
| Manufacturer | eSun |
|---|---|
| Model | PLA-Matte Dual |
| Material type | PLA |
| Colour | Green-purple |
| Filament diameter | 1.75 mm |
| Net filament weight | 1 kg |
| Printing technology | FDM |
| Surface finish | Matte |
| Nozzle temperature | 215–230 °C |
| Bed temperature | 45–60 °C |
| Recommended print speed | 40–300 mm/s |
| Cooling | 100% |
| Density | 1.174 g/cm³ |
| Tensile strength | 13.58 MPa |
| Elongation at break | 39% |
| Flexural strength | 56.72 MPa |
| Heat deflection temperature | 54 °C |
| Reference nozzle for print parameters | 0.4 mm; parameters may differ for other nozzle diameters |
| Feed requirement | The material is relatively soft; feed pressure must not be excessive |
| EAN | 6922572207967 |
|---|
Do I need to change filament to print a two-colour model?
No. Green and purple are combined in a single strand, allowing two-colour models without changing filament.
Do the listed settings apply to every nozzle?
The parameters are based on a 0.4 mm nozzle. Settings may differ with other nozzle diameters.












Gudri pirkumi vienuviet