Automašīnas palaišanas startera kabeļi vadi (Car Jumper Start Cables) - 800A 4m

-21%

Automašīnas palaišanas startera kabeļi vadi (Car Jumper Start Cables) - 800A 4m
Cena: 13.90€11.00 €
Preces kods:56387
Pieejamība:Ir veikalā
Atlikums: 2


Automašīnas palaišanas startera kabeļi vadi (Car Jumper Start Cables) - 800A 4m Automašīnas palaišanas startera kabeļi vadi (Car Jumper Start Cables) - 800A 4m Automašīnas palaišanas startera kabeļi vadi (Car Jumper Start Cables) - 800A 4m

Prece ir uzreiz pieejama mūsu veikalā Ūnijas ielā 11a (Karte). Var apskatīt un nopirkt uz vietas.
Lielas jaudas automašīnas palaišas kabeļu komplekts.

Kabeļa garums: 4 m
Paliek elastīgs zemā temperatūrā, iepakotas plastmasas maisiņā
Pilnībā izolēti termināli novērš īssavienojumu
Pirms lietošanas nepieciešams izlasīt instrukciju

4M 800A STARTING CABLES

  • a set of cables to start the vehicle with a discharged battery

  • copper clasps and wires

  • in the set a practical case

SPECIFICATION

  • intensity: 800A

  • diameter of the wire: 1.2 cm

  • length of wires with terminals: 4m

  • Weight: 2.1 kg

INCLUDED

  • 2 jump cables

  • case

Practical clamps with wires to help start the car with a discharged battery (using the current from the battery of another vehicle). Cables are always worth carrying with you in the trunk! In the event that the battery is discharged, we will be able to ask another driver for help. All you need to do is connect two cars and charge the battery.

The terminals and wires are copper - plated - it facilitates the flow of current and protects the terminals against corrosion. The silicone coating of cables is resistant to low temperatures. Can also be used in trucks. Long cables allow you to use the clamps even when you can not drive close to the vehicle.

How to choose the right cables:

  • 200A lines for starting petrol engines up to 900ccm

  • 400A lines for starting gasoline engines up to 1400ccm

  • 600A cables for starting petrol engines with a capacity up to 2000ccm

  • 600 - 1200A wires for starting diesel engines

How to use cables correctly:

  • the wires should be arranged so as to prevent contact with moving parts of the engine

  • the cable insulation should not be damaged

  • turn off the ignition switch in vehicles in which the electricity will be "borrowed"

  • gearbox levers in both vehicles should be in the loose position

  • put the red "+" clamp of the starter cable on the "+" terminal of the start-up vehicle battery

  • put the black clamp "-" the wire on the terminal "-" the discharged battery, and the other end of the cable "-" on the terminal "-" of the vehicle battery from which electricity will be drawn

  • start the vehicle's starter with a discharged battery for no longer than 3-5 seconds

  • if the vehicle's engine is not started, the test should be repeated several times (about 1 minute between tests), if after several (5-6 times) the vehicle fails to start, it should be submitted for repair

  • the start-up wires should be disconnected in reverse order than when installing


Automašīnas palaišanas startera kabeļi vadi (Car Jumper Start Cables) - 800A 4m (0)

Automašīnas palaišanas startera kabeļi vadi (Car Jumper Start Cables) - 800A 4m (0)


Automašīnas palaišanas startera kabeļi vadi (Car Jumper Start Cables) - 800A 4m (1)

Automašīnas palaišanas startera kabeļi vadi (Car Jumper Start Cables) - 800A 4m (1)


Automašīnas palaišanas startera kabeļi vadi (Car Jumper Start Cables) - 800A 4m (2)

Automašīnas palaišanas startera kabeļi vadi (Car Jumper Start Cables) - 800A 4m (2)